Lathe Disk Sander

I recently jumped into making segmented bowls. This is where several pieces of wood cut at a specific angle are glued together to create a circle. Once glued together, they leave a slightly uneven surface. I’ve been using a sheet of sandpaper attached to a small granite square, but this gets old pretty quick! I did some searching on YouTube and saw several people make a disk sander for the lathe. I gathered some materials, most of which I already had, and got to work. Check out the video below to see how it was made. Thanks everyone for the support! If you’d like to help support the content I create, make sure to stop by my store here, or go to Patreon and make a small monthly donation. Thanks again!